PRODUCT
-
Flow Meter
- Liquid
- Gas
- Level
- Pressure
- Temperature
-
Water Analysis
- GDC: General Display & Controller
- STU: Turbidity & SS
- Fluorescence Dissolved Oxygen
- IN-SITU Spectra Analyzer
- SCD/SS: Conductivity/Salinity
- SOW: PAH or Oil-in-Water
- SFC: Free Chlorine Sensor
- SANH:Ammonium/Nitrate ISE Sensor
- Smart Sensor
- SUM: Ultrasonic Sludge Blanket Monitor
- SUL:Ultrasonic Level Sensor
- Velocity Sensor
Precautions for the use of simulated transportation vibration testing machine
by:Sure
2021-08-19
1. The simulated transportation vibration tester is a simulated automobile transportation test for the packaging box after the product is packaged. Do not conduct a bare-metal test of the product to avoid scratching and damaging the sample. 2. The weight of the test sample should not exceed the maximum load, so as to avoid long-term overload use, which may increase the maintenance and shorten the life of the testing machine. 3. Fixation of the test sample: Place the item to be tested in the center of the workbench. 1. The simulated transportation vibration tester is a simulated automobile transportation test for the product packaging box. Do not perform the bare metal test of the product to avoid scratching and damaging the sample. . 2. The weight of the test sample should not exceed the maximum load, so as to avoid long-term overload use, which may increase the maintenance and shorten the life of the testing machine. 3. Fixation of the test sample: Place the item to be tested in the center of the workbench, move the four movable splints to fix the product with the locking screw. There is a gap of about 1mm between each plate and the packing box, which is not a firm clamp of the test product. die. 4. Turn on the power before the test starts, first turn the speed knob on the control panel to the minimum left, set the working time and then turn it to the required vibration speed for the test (the speed cannot be lower than 180RPM).
Custom message