PRODUCT
-
Flow Meter
- Liquid
- Gas
- Level
- Pressure
- Temperature
-
Water Analysis
- GDC: General Display & Controller
- STU: Turbidity & SS
- Fluorescence Dissolved Oxygen
- IN-SITU Spectra Analyzer
- SCD/SS: Conductivity/Salinity
- SOW: PAH or Oil-in-Water
- SFC: Free Chlorine Sensor
- SANH:Ammonium/Nitrate ISE Sensor
- Smart Sensor
- SUM: Ultrasonic Sludge Blanket Monitor
- SUL:Ultrasonic Level Sensor
- Velocity Sensor
Precautions for use of drop testing machine
by:Sure
2021-08-19
1. It is strictly forbidden for operators to stand under the falling arm, which is very dangerous. 2. Please carry out the test of the overweight test product in a hurry to avoid accidental injury to the operator due to the overweight. 3. It is strictly forbidden for personnel without professional training to enter the yellow cordon to do any related test operations when the power is on. 4. During the test, first drop the drop arm to the lowest point (ie: 300mm) and set the drop height. After the height is set, it is strictly forbidden to stand under the drop arm. 2. Please carry out the test of the overweight test product in a hurry to avoid accidental injury to the operator due to the overweight of the equipment. 3. It is strictly forbidden for personnel without professional training to enter the yellow cordon to do any related test operations when the power is on. 4. During the test, first lower the drop arm to the lowest point (ie: 300mm) and set the drop height. After the height is set, two operators will place the test object on the test board according to the required surface, corner and edge. , Fix it with a clamp. 5. After each test, the drop arm must be dropped to prevent the spring that has been reset for a long time from deforming the spring, which will affect the test effect. Please reset the position before the motor stops rotating before pressing the drop button. 6. After the new machine is installed at the factory, appropriate low-concentration engine oil must be added to the sliding rod. It is strictly forbidden to add anti-rust oil or high-concentration engine oil and the backlog of corrosive oils). 7. If there is too much dust in the oiling place due to a long time, please lower the machine to the lowest height, wipe off the previous oil, and then re-oil the machine. 8. The drop machine is an impact mechanical equipment. The screws must be tightened once every 500 times it is used to avoid loosening.
Custom message