Correct installation of centrifuge

1) Power supply voltage: The voltage fluctuation must meet the national standard within +10%, otherwise the centrifuges of some manufacturers will not operate normally. If the voltage fluctuates above this, it is recommended to use a voltage stabilizer to meet this grid. (2) The ground wire must be firm: the wiring of the power supply in the room must meet the requirements. Our country is a three-phase four-wire system. Three-phase is the three-phase of industrial electricity. When using three-phase electricity, the neutral line (1) Power supply voltage: Voltage fluctuations must meet the national standard within +10%, otherwise the centrifuges of some manufacturers will not operate normally. If the voltage fluctuates above this, it is recommended to use a voltage stabilizer to meet this grid. (2) The ground wire must be firm: the wiring of the power supply in the room must meet the requirements. Our country is a three-phase four-wire system. Three-phase is the three-phase of industrial electricity. When using three-phase electricity, the neutral wire is separated from the ground wire. More importantly, whether it is three-phase industrial electricity or general single-phase electricity, the ground wire should be reliable to avoid leakage. , The ground wire cannot be connected to the heating pipe or water pipe. (3) The ground should be flat and firm: For large centrifuges, the floor should be firm when moving at the installation site to ensure that the centrifuge rotor works normally without sinking in. The ground at the installation location should be flat and firm. (4) Find a good level: Find a more accurate small level, open the centrifuge cover, find the level on the main shaft, find the level by adjusting the adjustment bolts next to the 4 casters, pay attention to one of the legs not to fall out.